EN ▾
EnglishItalianoDeutschFrançaisEspañolPortuguêsČeštinaPolskiMagyarRomână
Download
  1. DrivePulse
  2. Fault codes
  3. Turbo
  4. P0299

P0299: turbocharger underboost

Compare requested and actual boost during firm acceleration from about 1,500 rpm, with the scan tool held by the passenger: if actual boost lags and the gap grows, air is escaping from a hose or the turbo is not pushing. You can drive gently to the garage, without full loads.

Get DrivePulse

What to look at in live data

Compare the boost pressure the ECU asks for with the actual one, if the car reports the boost control data; otherwise use intake manifold pressure minus barometric pressure. The right moment is firm acceleration from about 1,500 rpm upwards, on a road where it is safe, with the phone in the hands of the person in the passenger seat.

Actual pressure should follow the requested value closely. If it lags and the gap grows with revs, air is escaping from a hose or the intercooler, or the wastegate or the turbo vanes are not doing their job. With the ignition on and the engine off, the manifold pressure sensor should read almost the same as barometric pressure: if it doesn't, suspect the sensor first.

How serious is it and can you drive?

Severity is medium. Limp mode is there to protect the engine, and you can drive home or to a garage gently. Avoid full-throttle acceleration and overtaking. If you see blue smoke, lose oil or hear a metallic whistle that keeps rising, stop: the turbo could fail and push oil into the engine.

Switching off and restarting sometimes gets you out of limp mode, but the fault is still there and comes back at the next hard pull.

Read P0299 on your car

With an OBD2 adapter, DrivePulse reads your car's fault codes and tells you what they mean, whether you can drive and what to check. It's read-only: it writes nothing to the ECU.

Get DrivePulse

What it means

The turbo compresses the air going into the engine. A sensor in the intake manifold measures how much pressure actually arrives, and the ECU compares it with what it asked for at those revs and that load. If the pressure stays too low for a while, it stores P0299, known as underboost.

The code doesn't say which part has failed, only that boost is missing. So the first rule is not to start with the turbo, which is the most expensive part and often the least guilty.

Symptoms

  • Less power, especially when accelerating and uphill.
  • The car goes into limp mode: revs are capped lower and the engine feels held back.
  • A hiss or whoosh under load, a sign of air escaping.
  • On diesels, sometimes dark smoke when you accelerate.

Most likely causes, in order

  • A leak in the boost hoses between turbo, intercooler and manifold: a loose clamp or a cracked pipe. It's the most common cause and the cheapest.
  • A leaking intercooler, sometimes after a knock to the front of the car.
  • The turbo control: the valve that regulates boost or, on diesels, variable-geometry vanes clogged with soot that no longer move freely. A loose vacuum line is enough too.
  • The boost pressure sensor reading wrong.
  • A restricted exhaust, on diesels often a loaded particulate filter that chokes the turbo.
  • A worn turbo, with shaft play or oil leaks. It comes last, once everything else checks out.

What to check before the garage

  • With the engine off and cold, look at every hose between turbo and engine: cracks, loose clamps, pipes that have slipped off.
  • Look for oil traces on the hoses and around the joints: a film of oil often marks where the air gets out.
  • Check the air filter: if it's very dirty the turbo struggles.
  • See whether other codes are stored, for example on the particulate filter or the air mass sensor: they help you decide where to start.

At the garage: what to ask for

Ask for a boost leak test: the system is pressurised and you hear straight away where the air escapes. Then a check of the turbo control and a comparison of requested and measured boost. The turbo gets replaced only if everything else is fine.

What DrivePulse shows

DrivePulse reads P0299 and opens its card: what it means, whether you can drive, the causes in order and the checks to do. It also tells you whether the code is pending or confirmed.

In the live data, on cars that report them, you see manifold pressure and outside air pressure. When you accelerate the first must rise well above the second; if they stay almost equal, the turbo isn't pushing. On cars that expose it, the Dashboard also shows boost. While driving, the passenger watches the screen, not the driver.

Frequently asked questions

Can I drive with P0299?

Yes, gently and without full throttle, as far as the garage. If blue smoke or oil leaks appear, it's better to stop.

Will cleaning or replacing the turbo fix it?

Only if the turbo is the culprit. In most cases the air escapes from a hose or a clamp, and a leak test finds it within minutes.

Why does it appear after short trips in town?

On diesels the variable-geometry vanes get dirty with soot if the car only does short trips. A longer drive at steady speed sometimes frees them, but if the code returns it needs checking.

Related codes

Related guides

What you need to read it

All you need is an ELM327 OBD2 adapter, plugged into the diagnostic port, usually under the steering wheel. On iPhone it has to be Bluetooth Low Energy (BLE) or Wi-Fi, like the Veepeak OBDCheck BLE or the Vgate iCar Pro 2S; on Android classic Bluetooth adapters work too, once paired in the phone's settings. Veepeak recommends DrivePulse to its customers, and the Vgate is the one the Italian site Macitynet tested together with the app. The full list is on Which adapters work.

DrivePulse is on iPhone and Android. It's read-only: it writes nothing to the ECU and doesn't clear codes. You try it for 7 days from the first connection or for 15 trips, whichever comes first, then unlock it with a single purchase, no subscription and no account.

← All codes