What to look at in live data
The most useful value is readiness monitor status: one of the monitors covers the fuel vapour system. After tightening or replacing the cap, watch when that monitor goes from not complete to complete: if it completes and the code does not come back, it is fixed.
The test only runs under certain conditions, which vary by car: usually with the tank between about a quarter and three quarters full and after the car has been parked for a few hours. Check fuel level in the data: with the tank nearly full or nearly empty the test may not run for days.
How serious is it and can you drive?
Severity is low. You can drive normally: the engine isn't affected. The only costs of ignoring it are a little petrol vapour lost to the air and a light that hides other codes. It's worth fixing before an inspection.
Read P0456 on your car
With an OBD2 adapter, DrivePulse reads your car's fault codes and tells you what they mean, whether you can drive and what to check. It's read-only: it writes nothing to the ECU.
Get DrivePulseWhat it means
Petrol gives off vapour, and the evaporative emission system, EVAP, keeps it from escaping: the vapour goes into a charcoal canister and is later drawn into the engine and burnt. To check the system is sealed, the ECU runs a leak test, often with the engine off or after the car has stood, by sealing the system and watching whether pressure or vacuum holds. With P0456 it says the system loses pressure very slowly: a leak about the size of a pinhole.
Many European cars don't run this test, so the code is far more common on cars built for the American market.
Symptoms
- Usually none: just the check engine light.
- Sometimes a faint smell of petrol near the car.
- The car may fail an emissions inspection where the check is done.
Most likely causes, in order
- The fuel cap seal, hardened or cracked, or a cap not tightened until it clicks.
- A micro-crack in an EVAP hose or a loose clamp.
- The filler neck seal or the canister's vent valve.
- The leak detection unit itself, less often.
What to check before the garage
- Tighten the fuel cap until it clicks, and look at its rubber seal: if it's cracked or flattened, a new cap is the cheapest first attempt.
- After changing or tightening the cap, drive normally for a few days: the ECU needs to rerun its test before the light goes out.
- If you smell petrol strongly, that's no longer a very small leak: have it checked soon.
At the garage: what to ask for
A smoke test of the EVAP system: harmless smoke is pushed into the system and you see where it comes out. It finds pinhole leaks that are impossible to spot by eye.
What DrivePulse shows
DrivePulse reads P0456 and opens its card, with the advice to try the fuel cap first. It tells you whether the code is pending or confirmed: after a new cap, a code that stays pending and then disappears means the fix worked.
The Before the inspection card shows how many self-tests are ready, including the EVAP one on cars that run it.
Frequently asked questions
Can I drive with P0456?
Yes, normally. The engine isn't affected. Fix it when convenient, and before an emissions inspection.
Will a new fuel cap fix P0456?
Often, yes: the cap seal is the most common cause. After fitting it, the light can take a few days of driving to go out.
What's the difference from P0455 and P0442?
They describe leaks of different sizes: P0455 large, P0442 small, P0456 very small. The checks start from the fuel cap in every case.
Related codes
Related guides
- Buying a used car? What to check: a code cleared just before the sale shows up in the distance driven since the last clear.
What you need to read it
All you need is an ELM327 OBD2 adapter, plugged into the diagnostic port, usually under the steering wheel. On iPhone it has to be Bluetooth Low Energy (BLE) or Wi-Fi, like the Veepeak OBDCheck BLE or the Vgate iCar Pro 2S; on Android classic Bluetooth adapters work too, once paired in the phone's settings. Veepeak recommends DrivePulse to its customers, and the Vgate is the one the Italian site Macitynet tested together with the app. The full list is on Which adapters work.
DrivePulse is on iPhone and Android. It's read-only: it writes nothing to the ECU and doesn't clear codes. You try it for 7 days from the first connection or for 15 trips, whichever comes first, then unlock it with a single purchase, no subscription and no account.