EN ▾
EnglishItalianoDeutschFrançaisEspañolPortuguêsČeštinaPolskiMagyarRomână
Download
  1. DrivePulse
  2. Fault codes
  3. Cooling and oil
  4. P0128

P0128: coolant temperature below thermostat regulating temperature

Follow the coolant temperature from a cold start, with the phone held by the passenger: on most cars it reaches about 85 to 95 °C after 10 to 15 minutes and stays there; if it stops much lower, the thermostat is stuck open. You can drive, but in winter a weak heater clears the windscreen poorly.

Get DrivePulse

What to look at in live data

While someone else drives and the phone is held by the person in the passenger seat, follow coolant temperature from a cold start: on most cars it reaches about 85-95 °C after 10-15 minutes of normal driving and then stays there. If it climbs slowly and settles much lower, or drops on the motorway and rises again in town, the thermostat is staying open.

After the car has stood overnight, before starting, compare coolant temperature with intake air temperature: they should be almost the same. If they are far apart, the problem may be the temperature sensor rather than the thermostat, and replacing the thermostat would not be enough.

Read P0128 on your car

With an OBD2 adapter, DrivePulse reads your car's fault codes and tells you what they mean, whether you can drive and what to check. It's read-only: it writes nothing to the ECU.

Get DrivePulse

What it means

P0128 means the coolant temperature stays below the thermostat's opening temperature. After a certain amount of driving, the ECU expects the coolant to reach around 80 to 90 °C. If it stays colder for too long, it stores the code.

Why it happens mostly in winter

The thermostat keeps coolant away from the radiator until the engine is warm. If it sticks open, coolant flows through the radiator from the start. In summer you hardly notice. In the cold, and especially on the motorway, the engine never reaches its temperature.

Symptoms

  • A weak cabin heater that blows lukewarm air.
  • The temperature gauge lower than usual, or dropping on the motorway.
  • Higher fuel consumption, because the ECU enriches the mixture as if the engine were cold.

Most likely causes

  • A thermostat stuck open through wear. It's the typical cause.
  • A drifting coolant temperature sensor that reads lower than reality.
  • A low coolant level.

What to do

  • Check the coolant level with the engine cold. Never open the cap on a hot engine.
  • If the level is right, the thermostat needs replacing at a garage. The part is inexpensive and the job takes around an hour.
  • It's not as urgent as other codes, but while you wait the car uses more fuel. An engine that always runs cold wears more, and the oil gets diluted with unburnt fuel.

When to see a mechanic

  • The coolant level keeps dropping, which suggests a leak.
  • The heater no longer warms the cabin.
  • The temperature rises instead of staying low. That's the opposite problem and needs checking straight away.

What DrivePulse shows

DrivePulse shows coolant temperature live, on the Dashboard and on CarPlay. In Health it tells you when the engine is still warming up. Statistics work out how many minutes on average it takes to reach temperature.

If on long trips the coolant stays cooler than usual, the Analysis flags it with the title «The engine does not reach temperature» and suggests having the thermostat checked. The P0128 card lists the causes, the symptoms that confirm it and what to do.

Frequently asked questions

Can I drive with P0128?

Yes, it's not a fault that leaves you stranded. In winter, though, a weak heater demists the windscreen poorly, which is also a safety issue. Better not to put it off for long.

Does the coolant need changing too?

When the thermostat is replaced some coolant comes out. It must be topped up with the type the manufacturer specifies, and the system bled of air.

Why does the engine run cold only on the motorway?

Because at speed the air through the radiator cools the coolant a lot. With a thermostat stuck open, that's enough to keep the engine below its temperature even in mild weather.

Related codes

Related guides

What you need to read it

All you need is an ELM327 OBD2 adapter, plugged into the diagnostic port, usually under the steering wheel. On iPhone it has to be Bluetooth Low Energy (BLE) or Wi-Fi, like the Veepeak OBDCheck BLE or the Vgate iCar Pro 2S; on Android classic Bluetooth adapters work too, once paired in the phone's settings. Veepeak recommends DrivePulse to its customers, and the Vgate is the one the Italian site Macitynet tested together with the app. The full list is on Which adapters work.

DrivePulse is on iPhone and Android. It's read-only: it writes nothing to the ECU and doesn't clear codes. You try it for 7 days from the first connection or for 15 trips, whichever comes first, then unlock it with a single purchase, no subscription and no account.

← All codes