What to look at in live data
The cylinder 4 misfire counter, in the on-board test results (mode 06) if the car reports them, is the value to follow: after every test or repair it tells you whether the misfires really drop. Read it at three different moments, cold, warm at idle and on an uphill stretch with the phone in the hands of the person in the passenger seat, because each one points to a different cause.
Alongside it, watch long term fuel trim and coolant temperature: a cylinder that misfires cold and settles once warm, with normal trims, suggests an injector or a valve that doesn't seal well; trims that are high only at idle suggest an air leak near cylinder 4. If the spark plug well had oil or water in it, after the seal is fixed the counter should fall to zero or close to it.
How serious is it, can you drive?
Severity is high. With a steady light and an engine running almost smoothly, you can reach the garage driving gently and without revving hard. With a flashing light, slow down and stop as soon as it's safe: unburnt fuel overheats the catalytic converter and can damage it.
Read P0304 on your car
With an OBD2 adapter, DrivePulse reads your car's fault codes and tells you what they mean, whether you can drive and what to check. It's read-only: it writes nothing to the ECU.
Get DrivePulseWhat it means
Each firing gives the crankshaft a small push. Through the engine speed sensor, the ECU feels when one of these pushes is missing, and from the crankshaft position it knows which cylinder was due. With P0304 the missed firings in cylinder 4 have gone over the limit.
If there are enough misses to put the catalytic converter at risk, the light doesn't stay steady but flashes. That's the signal never to ignore.
Symptoms
- Engine shaking at idle, with vibration in the steering wheel or the gear lever.
- Hesitation when you accelerate, especially at full load or uphill.
- Fuel consumption going up and power going down.
- Check engine light steady, or flashing if the misfires are frequent.
Most likely causes, in order
- The cylinder 4 coil, often with a cracked or burnt rubber boot.
- The cylinder 4 spark plug, worn or fouled with oil.
- Oil or water in the spark plug well, which lets the spark short to ground.
- The cylinder 4 injector, dirty or not closing properly.
- A loss of compression in cylinder 4, from a valve or the head gasket.
When it happens: cold, at idle or under load
If the engine misses only in the first few minutes from cold, or in damp weather, suspicion falls on the coil or its boot, which in the cold let the spark escape where it shouldn't.
If it happens mostly when you accelerate hard or climb, the spark can't cope with the high pressure in the cylinder: again plug or coil. If instead the problem is there at idle and goes away as the revs rise, look at the injector and at air leaks.
Oil or water in the spark plug well
The plug sits at the bottom of a well in the cylinder head. If the valve cover gasket leaks, oil can run down into it: the coil boot swells, perishes and the spark jumps to the metal instead.
When the coil is replaced, it's worth pulling it out and looking at the bottom of the well: if there's oil, it must be cleaned and the gasket redone, or the new coil will be ruined before long too.
At the garage: what to ask for
Swapping the cylinder 4 coil with another cylinder's: if the code becomes the other cylinder's, the coil is the culprit. Then a check of the plug, the well and, if needed, the injector and compression. In order of cost: plug, coil, valve cover gasket, injector, engine work.
What DrivePulse shows
DrivePulse reads P0304 and opens the misfire card, which starts from plug and coil and tells you to stop if the light flashes; it also shows whether the code is pending or confirmed.
On cars that provide them, Health shows the misfire counters cylinder by cylinder: after swapping the coil you see whether the misses stay on cylinder 4 or move. After the repair, Before the inspection shows when the self-tests are ready again.
Frequently asked questions
Can I drive with P0304?
With a steady light, gently and as far as the garage. If the light flashes, slow down and stop as soon as you can.
Which one is cylinder 4?
On an inline four it's the one at the end of the row, usually the furthest from the timing belt or chain. The workshop manual confirms it.
Do I need to replace all four coils?
No: if the swap shows that only one coil is at fault, that one is replaced. Spark plugs, on the other hand, are usually changed all together.
Related codes
Related guides
- Buying a used car? What to check: a code cleared just before the sale shows up in the distance driven since the last clear.
What you need to read it
All you need is an ELM327 OBD2 adapter, plugged into the diagnostic port, usually under the steering wheel. On iPhone it has to be Bluetooth Low Energy (BLE) or Wi-Fi, like the Veepeak OBDCheck BLE or the Vgate iCar Pro 2S; on Android classic Bluetooth adapters work too, once paired in the phone's settings. Veepeak recommends DrivePulse to its customers, and the Vgate is the one the Italian site Macitynet tested together with the app. The full list is on Which adapters work.
DrivePulse is on iPhone and Android. It's read-only: it writes nothing to the ECU and doesn't clear codes. You try it for 7 days from the first connection or for 15 trips, whichever comes first, then unlock it with a single purchase, no subscription and no account.