What to look at in live data
The ECU decides how long to keep the glow plugs on based on coolant temperature. After the car has stood overnight, before starting, compare that value with the outside temperature: they should be close. If the sensor reads warm on a cold engine, the glow plugs stay off and the car starts badly even with good glow plugs.
Watch the voltage too as you turn the key on a cold engine: glow plugs draw a lot of current, so in the first few seconds the voltage drops visibly. If it does not change at all, the glow plugs are probably getting no current: the relay, the glow plug module or the wiring. If the car reports the module status, it should show as on during those seconds.
How serious is it and can you drive?
Severity is medium. In mild weather you can drive without problems, because a diesel starts even without glow plugs. The trouble comes with the cold: long cranking, strain on the starter and battery, more smoke and more soot in the particulate filter. It's worth fixing before winter.
Read P0380 on your car
With an OBD2 adapter, DrivePulse reads your car's fault codes and tells you what they mean, whether you can drive and what to check. It's read-only: it writes nothing to the ECU.
Get DrivePulseWhat it means
A diesel ignites by compression: compressed air gets hot enough to burn the fuel. When cold that isn't enough, so the glow plugs, one per cylinder, heat the combustion chamber for a few seconds before and after starting. A dedicated module or relay controls them. With P0380 the engine ECU says the glow plug circuit isn't responding as expected.
Symptoms
- Hard cold starts, sometimes several attempts.
- White or grey smoke in the first seconds after starting.
- A rough engine for the first minute, then normal.
- Glow plug light on or flashing.
Most likely causes, in order
- One or more glow plugs open circuit: they wear out over the years.
- The glow plug module or relay.
- A fuse or a corroded connector on the plugs.
- The wiring to the glow plugs, cooked by engine heat.
What to check before the garage
- Check that the glow plug light comes on when you turn the key and goes out after a few seconds, as usual.
- Note how the car starts when cold and at what outside temperatures.
- Check the battery as well: a weak battery makes cold starts much worse and can muddy the picture.
At the garage: what to ask for
A resistance or current draw test on each glow plug and a check of the module that drives them. They're often replaced as a set. On some engines old glow plugs seize in the cylinder head, and removing them needs care: a garage used to diesels avoids snapping them.
What DrivePulse shows
DrivePulse reads P0380 and opens its card, with the advice to fix it before winter. In Health, the cranking battery test shows how far the voltage drops while the starter turns: with faulty glow plugs starts take longer, and the battery suffers.
On diesels, DPF status helps you see whether, with hard starts and more smoke, the particulate filter is loading up faster.
Frequently asked questions
Can I drive with P0380?
Yes. In summer there are hardly any symptoms. In the cold the car struggles to start: it's worth fixing before winter.
Should all the glow plugs be replaced?
Often yes, because they age together. Only the faulty one is replaced if the others test fine and are recent.
Why is there white smoke on starting?
Because without glow plugs the fuel burns poorly in the first seconds when cold, and some of it leaves unburnt as light smoke.
Related codes
Related guides
- Buying a used car? What to check: a code cleared just before the sale shows up in the distance driven since the last clear.
What you need to read it
All you need is an ELM327 OBD2 adapter, plugged into the diagnostic port, usually under the steering wheel. On iPhone it has to be Bluetooth Low Energy (BLE) or Wi-Fi, like the Veepeak OBDCheck BLE or the Vgate iCar Pro 2S; on Android classic Bluetooth adapters work too, once paired in the phone's settings. Veepeak recommends DrivePulse to its customers, and the Vgate is the one the Italian site Macitynet tested together with the app. The full list is on Which adapters work.
DrivePulse is on iPhone and Android. It's read-only: it writes nothing to the ECU and doesn't clear codes. You try it for 7 days from the first connection or for 15 trips, whichever comes first, then unlock it with a single purchase, no subscription and no account.