What to look at in live data
The comparison that counts is commanded throttle against actual position: the standard data includes commanded throttle actuator and absolute throttle position. At idle, with the engine warm, they should stay close; with short blips of the throttle while parked, the actual position should follow the command with no lag or bounce.
If the actual position arrives late or stops short, the motor is struggling: usually because of oil and soot deposits around the plate, sometimes worn gears. If it lags only when the battery is weak, check the control module voltage too. After cleaning the throttle body, many cars need the position learning procedure, or idle stays unsettled and the code can return.
How serious is it, can you drive?
Severity is high, not for the engine but for safety: the ECU can cut power suddenly, perhaps while overtaking or joining a fast road. Drive carefully only as far as the garage, avoiding overtakes and roads where you need to accelerate firmly. If the engine stalls or stops responding to the pedal, stop somewhere safe.
Read P0638 on your car
With an OBD2 adapter, DrivePulse reads your car's fault codes and tells you what they mean, whether you can drive and what to check. It's read-only: it writes nothing to the ECU.
Get DrivePulseWhat it means
The throttle body controls the air entering the engine. An electric motor opens and closes the throttle flap, and two position sensors tell the ECU where it is. The ECU constantly compares the requested position with the real one.
With P0638 the difference is too big or lasts too long: the flap moves with difficulty, sticks or doesn't respond. For safety the ECU usually limits the engine, which is left with little power and a high idle. On diesels the same code can concern the intake throttle flap, used for the EGR, for DPF regenerations and to stop the engine smoothly.
Symptoms
- Engine light on, often with the accelerator or limp mode light.
- Power drops suddenly and the car responds poorly to the pedal.
- High or rough idle, sometimes the engine stalling when you lift off.
- It may appear with throttle sensor codes, such as P2135.
Most likely causes, in order
- A throttle body coked with carbon: oil vapour and, on diesels, EGR gases form a crust that drags on the flap.
- The throttle motor is worn, or its gears are damaged.
- The throttle body connector or wiring.
- Low battery voltage making the motor work badly, more rarely.
What to check before the garage
- With the engine off, check that the throttle body connector is fully seated, with no corrosion.
- The battery condition: low voltage can upset the throttle motor.
- Don't clean the throttle by forcing it open by hand or with the ignition on: you risk damaging the motor, and after cleaning a position relearn is needed anyway.
At the garage: what to ask for
A throttle body test with the diagnostic tool, a clean if it's coked up, and then a position relearn. If the motor is worn or the sensors disagree, the throttle body is replaced. The wiring and connector should be checked too.
What DrivePulse shows
DrivePulse reads P0638 and opens its card with causes, checks and when to stop, and tells you whether the code is pending or confirmed.
In Health, the resting battery voltage and the cranking test rule out the simplest cause. Alongside P0638, DrivePulse also shows any throttle sensor codes.
Frequently asked questions
Can I drive with P0638?
Only to the garage, carefully: power can drop suddenly. Avoid overtaking and fast merging.
Is cleaning the throttle body enough?
It often helps, but a position relearn is needed afterwards, and if the motor is worn cleaning isn't enough.
What's the difference from P2135?
P2135 says the two throttle position sensors disagree. P0638 says the throttle isn't following the ECU's command.
Related codes
Related guides
- Buying a used car? What to check: a code cleared just before the sale shows up in the distance driven since the last clear.
What you need to read it
All you need is an ELM327 OBD2 adapter, plugged into the diagnostic port, usually under the steering wheel. On iPhone it has to be Bluetooth Low Energy (BLE) or Wi-Fi, like the Veepeak OBDCheck BLE or the Vgate iCar Pro 2S; on Android classic Bluetooth adapters work too, once paired in the phone's settings. Veepeak recommends DrivePulse to its customers, and the Vgate is the one the Italian site Macitynet tested together with the app. The full list is on Which adapters work.
DrivePulse is on iPhone and Android. It's read-only: it writes nothing to the ECU and doesn't clear codes. You try it for 7 days from the first connection or for 15 trips, whichever comes first, then unlock it with a single purchase, no subscription and no account.